Waveshare Platform Cable USB for all Xilinx devices

Overview
The Platform Cable USB a USB compatible cable for in-circuit configuration and programming of all Xilinx devices. It is compatible with the original XILINX Platform Cable USB.

Features
Performance
Using CY7C68013A+FPGA solution, fully compatible with the original XILINX Platform Cable USB
Programs all Xilinx devices, including FPGAs / CPLDs / ISP Configuration PROMs
Supports JTAG, Slave-Serial and SPI programming, to config all Xilinx devices
Interfaces to devices operating at 5V / 3.3V / 2.5V / 1.8V / 1.5V
Optional target clock frequency, supports XILINX software automatic frequency adjustment
Firmware auto upgrade, it's possible to support more new released software and devices
Anti-static and multi-layers signal isolation, to protect the target and the programmer itself
Supported software
Xilinx ISE
iMPACT
ChipScope
Vivado
Supported devices
Xilinx FPGA devices: UltraScale / 7 series / Zynq / Kintex / Virtex / Artix / Spartan, etc.
Xilinx CPLD devices: XC9500 / XC9500XL / XC9500XV / CoolRunner XPLA3 / CoolRunner-II, etc.
Xilinx PROM devices: Platform Flash XCF00S / XCF00P / XL, etc.

LED Status
Red: USB connected
Yellow: USB connected, and Vref (the target board) is powered

Note: please make sure the VCC and GND are connected correctly, to avoid damaging the Platform Cable USB

PACKAGE CONTENT
Platform Cable USB main unit x1
JTAG adapter x1
USB cable x1
8-pin header to 7-pin separated cable x1
8-pin header to 6-pin header cable x1
14-pin (2.54mm pitch) JTAG cable x1
14-pin (2mm pitch) JTAG cable x1
10-pin (2.54mm pitch) JTAG cable x1
Development Resources

Wiki : www.waveshare.com/wiki/Platform_Cable_USB